Guitar Amplifier Electronics Recipes book

Guitar Amplifier Electronics: Recipes

Richard Kuehnel

For the experienced builder, this book cuts through the noise. Forget lengthy explanations and dive directly into the essential procedures and formulas needed for guitar amplifier circuit design. Inside, you'll find step-by-step procedures for designing

  • triode and pentode voltage amplifiers,
  • voltage amplifiers with parallel triodes,
  • tone stacks tailored to your circuit's requirements, including insertion loss, knob count, and the required driving circuit,
  • split-load and long-tailed-pair phase inverters,
  • single-ended and push-pull power amplifiers, including negative feedback implementations, and
  • vacuum-tube and solid-state DC power supplies.

Get ready to streamline your process and produce extraordinary results!

Richard Kuehnel is a member of the Circuits and Systems Society of the Institute of Electrical and Electronic Engineers.

Introduction

Warning: High Voltage!...1
Why the Prerequisites?...2
Voicing...3
Acknowledgements...3

Design a Fixed-Bias Triode Voltage Amplifier

Prerequisites...4
Procedure...4
Example...7

Design a Cathode-Bias Triode Voltage Amplifier

Prerequisites...15
Procedure...15
Example (12AX7)...18
Example (12AY7)...24
Example (6SL7/12SL7)...30

Design a Cathode-Bias Pentode Voltage Amplifier

Prerequisites...37
Procedure...38
Example (EF86)...40
Example (6SJ7/12SJ7)...51
Example (5879)...61

Design a Voltage Amplifier with Parallel Triodes

Prerequisites...71
Procedure...71
Example...74

Select a Tone Stack

Prerequisites...82
Procedure...82
Examples...82
Schematics and Performance Details...83
Fender Princeton 6G2...83
Supro Thunderbolt S6420...84
Orange OR120 (Graphic Mk II)...85
A Fender Twin Reverb Inspiration...86
Marshall Model 1987 "Plexi"...87
Fender Bassman 5F6-A...88
Vox AC30 Silver Jubilee...89
Fender Twin 5D8...90

Design a Split-Load Phase Inverter

Prerequisites...92
Procedure...92
Example...93

Design a Long-Tailed-Pair Phase Inverter

Prerequisites...100
Procedure...100
Example (12AX7)...102
Example (12AT7)...109

Design a Single-Ended Power Amp

Prerequisites...117
Procedure...117
Example (6V6)...119
Example (EL84)...129

Design a Push-Pull Power Amp

Prerequisites...151
Procedure...151
Example (6V6)...154
Example (EL84/6BQ5)...162

Design Feedback for a Single-Ended Power Amp

Prerequisites...171
Procedure...172
Example...173

Design Feedback for a Push-Pull Power Amp

Prerequisites...177
Procedure...178
Example...179

Design a Power Supply with a Vacuum Tube Rectifier

Prerequisites...181
Procedure...181
Example...182

Design a Power Supply with a 1N4007 Rectifier

Prerequisites...186
Procedure...186
Example...187

Some Final Words...194


Amp Books company logo Amp Books®   About Us | Legal Notice | Contact
Copyright © 2005-2025 Amp Books LLC
All Rights Reserved